To Next Page

To Previous Page

460

Celerra Network Server Command Reference Manual

The server Commands

Ethernet speed={10 | 100 | 1000 |auto}

Sets the speed for the port. auto (default) turns on

autonegotiation; setting a fixed speed disables autonegotiation.

duplex={full | half | auto}

Sets the duplex to full, half, or auto. auto (default) turns

autonegotiation on; setting a fixed duplex disables

autonegotiation.

CAUTION

The speed and duplex settings on both sides of the physical

connection must be the same. Mismatched speed and duplex

settings can cause errors and impact network performance. For

example, if the duplex is set to half on one end and full on the

other, there might be network errors and performance issues.

Gigabit Ethernet Fiber For Gigabit Ethernet Fiber connections, the speed is automatically

set to 1000, and since it must remain at that setting, no speed

setting is required.

linkneg={enable | disable}

Disables autonegotiation on the network adapter card if it is not

supported by the network Gigabit switch. The default is enable.

rxflowctl={enable | disable}

Enables the ability to accept and process pause frames.The

default is disable.

txflowctl={enable | disable}

Enables pause frames to be transmited. The default is disable.

Gigabit Ethernet

Copper

speed={10 | 100 |1000 |auto}

Sets the speed for the port. auto (default) turns on

autonegotiation; setting a fixed speed disables autonegotiation.

duplex={full | half | auto }

Sets the duplex to full, half, or auto. auto (default) turns

autonegotiation on; setting a fixed duplex disables

autonegotiation.

EMC Celerra User Manual

Other manuals for EMC Celerra