To Next Page

To Previous Page

fs_dhsm

The fs Commands

Note: The full migration may take several minutes or hours if the file is

very large.

-httpport <port>

Specifies the remote port number that the Data Mover delivers

the HTTP request to. If not specified, the Data Mover issues

HTTP requests to port 80 on the secondary storage HTTP server.

-localport <port>

Specifies the local port number the Data Mover uses to issue

HTTP requests to the web server running on the secondary

storage. The <port> specified should be an integer no less than

1024. If not specified, the Data Mover selects a port to issue the

HTTP requests.

Note: The two end points of an HTTP connection are specified by the file

system name and the value specified for the -secondary option. If

multiple connections are created using identical end points with

different attributes such as, -cgi, -user, -password, -localPort, -httpPort,

the connection will fail.

[-user <username>]

Defines the username the HTTP client uses if digest

authentication is required by the secondary storage HTTP server.

[-password <password>]

Allows the user to specify the admin password. The password is

not recorded in the command log. If the -password option is

given but no password is specified, the user is prompted

interactively.

Use the -password option when digest authentication is required

by the secondary storage HTTP server.

[-timeout <seconds>

Specifies the timeout value in seconds. By default, the Celerra

HTTP client waits 30 seconds for a reply from the HTTP server

and then retries the operation once.

[-cgi {y|n}

Specifies the HTTP connection type: CGI or non-CGI. By default,

FileMover assumes that the web server is using CGI connections

to access migrated file data via a CGI application. For non-CGI

EMC Celerra User Manual

Other manuals for EMC Celerra