12
Install - Step 1 continued
Install the storage-system hardware
Installing the SPS rail kits
a. From the front of the cabinet, insert the alignment pin on one mounting rail
assembly into the middle hole of the selected 1U space on a rear channel.
b. Extend the rail to the front cabinet channel. Align the holes of the front rail
flange to the inside of the channel, ensure the rail is level, and then install two
M5 x 16 mm Phillips securing screws in the top and bottom holes.
Leave the screws slightly loose to allow for adjustment when you install the tray. Do not insert a
screw in the middle hole yet.
c. At the back of the cabinet, insert and tighten two M5 x 16 mm securing screws
in the holes above and below the alignment pin, as shown above. Repeat steps
a through c for the other rail assembly.
EMC3253
Adjustable rail
Alignment pin
Alignment pin
Front
Left front
Screw (2)
Mounting rail
Right rear
Screw (2)
Mounting rail
Alignment pin
To Next Page
Loading...
