EMC CLARiiON CX4-120 - Securing the SPS Tray to the Mounting Rails

13
Install - Step 1 continued
Install the storage-system hardware
d. Slide the tray onto the mounting rails in the cabinet, until the flanges of the
tray are flush with the cabinet channels.
Securing the SPS tray to the mounting rails
e. Do not insert any new screws, but tighten the four securing screws (two on
each side) that hold the mounting rails to the channels.
f. Working from the front of the cabinet, slide the SPS units onto the tray.
If you have a single SPS, insert it on the left (from the front view) side of the SPS tray.
EMC3252
Rear