EMC CLARiiON CX4-120 - Install the Unisphere Server Utility

46
Install - Step 11 continued
Prepare the servers
For QLogic iSCSI HBAs only:
Install the supported version of the SANsurfer software as follows:
1. Open a web browser and connect to the QLogic website:
http://support.qlogic.com/support/oem_emc.asp
2. Go to the Downloads page.
3. Select the appropriate host bus adapter.
4. Select and download the software and related documentation.
Assign IP addresses to NICs or iSCSI HBAs
Use the card/adapter vendor’s documentation to assign an IP address to each
initiator port on your server’s NICs or iSCSI HBAs.
Install path management software
Install PowerPath on each server. If you have supported path management
software other than PowerPath, install it on each server as described in the software
documentation.
Install the Unisphere Server Utility
Download and install the Unisphere Server Utility from Powerlink.
a. From the Powerlink website, select Support > Software Downloads and
Licensing > Downloads T-Z > Unisphere Server Software.
b. Select the Unisphere Server Utility, and then select the option to save the
software to your server.
c. Double-click the following executable file to start the installation wizard:
UnisphereInitUtil-Win-32-x86-language-version-build.exe where:
language is either en_US, when only the English version is available, or loc,
when the localized versions are available (including English). version and build
are the version number and the build number of the software.
d. Follow the instructions on the installation screens and accept all the defaults.
D
E
F