17
Install - Step 1 continued
Install the storage-system hardware
b. With help from another person, lift the enclosure and, from the front of the
cabinet, slide the enclosure onto the rails as shown below.
Sliding the enclosure onto the mounting rails
c. When the enclosure slides to the back of the cabinet, the two notches in the
rear of the enclosure insert into the rear tabs on each rail. The tabs secure and
support the rear of the enclosure.
d. If the chassis does not slide all the way into the cabinet, you may need to
further loosen the screws that hold the rear of the rails in place, then adjust the
rails to allow the tabs to fit into the notches.
e. Once the enclosure is completely seated into the rear tabs, tighten the two
screws (one on each rail) that secure the rails to the front channels.
CL4137
To Next Page
Loading...
