53
Install - Step 14 continued
Configure and register iSCSI connections
9. Click Logon to connect to the selected target. Click OK.
10. Repeat steps 6 – 9 for any other target to which you want to log in.
11. Click Next. The Server Registration window opens and lists all connected storage
systems. Make certain that a path is shown for each connection. If paths are
missing, ensure that you are logged in to the expected targets.
12. In the Server Registration window, click Next to send the updated information to
the storage system and register the server with all connected storage systems. The
wizard displays a success message.
13. Click Finish to close the wizard.
For iSCSI HBAs
On each server that connects to the storage system with a QLogic iSCSI HBA:
1. Open QLogic SANsurfer and configure Target Settings for your server as
described in the QLogic documentation.
2. Start the Unisphere Server Utility:
Start > Programs > EMC > Unisphere > Unisphere Server Utility or Start > All
Programs > EMC > Unisphere > Unisphere Server Utility
3. Select Register this server to all connected storage systems, and click Next.
4. Click Next to send the server information to the storage system.
5. Click Finish to exit the utility.
The utility sends the initiator records for the HBA initiators in the server to each storage
system that is connected to the server.
To Next Page
Loading...
