57
Install - Step 17
Register the Fibre Channel HBAs
On each server that uses a Fibre Channel host bus adapter, run the server utility to
register the HBAs with the storage system.
If the utility does not list (“see”) your storage processors, make sure the storage system is
powered up.
1. Start the server utility:
Start > Programs > EMC > Unisphere > Unisphere Server Utility or Start > All
Programs > EMC > Unisphere > Unisphere Server Utility
2. Select Register this server to all connected storage systems, and click Next.
3. Click Next to send the server information to the storage system.
4. Click Finish to exit the utility.
The utility sends the initiator records for the HBA initiators in the server to each
storage system that is connected to the server.
To Next Page
Loading...
