Section 3: Installation
WARNING:
Failure to follow instructions for proper electrical wiring, storage, setup, and
maintenance may cause serious injury, damage equipment, or void warranty.
WARNING:
Use caution when working on, with, or around valves and actuators.
High pressures, forces, voltages, and flammable media can be present.
3.1 Preparing the Stem Nut
NOTE:
The actuator can be direct mounted to the valve shaft or stem, or can be close coupled to
the auxiliary gear drives. See Appendix for the appropriate drawings.
Figure 3-1 Preparing the Stem Nut
TEC2000/TEC2 Enclosure
Model 500 Enclosure
To Next Page
Loading...
