Emerson Bettis 500 - Change Settings

Installation and Operation Manual
E2K-405-0218 Rev. 2 February 2018
45
Section 5: Customizing Actuator Settings
Customizing Actuator Settings
5.5 Change Settings
1. Enter “SETUP” mode and use the selector knob (NEXT) to scroll to “CHANGE
SETTINGS?”. Answer “YES.” See Section 5.1, Entering Setup Mode.
2. Enter passcode.
NOTE:
A passcode must be entered to change settings.
3. Use the selector knob (NEXT/BACK) to scan the display for the desired setting to
change the following:
• Valve control setup
• Valve travel limits
• Discrete input
• Discrete output
• Inhibit and ESD
• Two-speed timer
• Analog
• Network
• Tag name
• Passcode