Emerson Bettis 500 - Figure 5-13 Analog Setup

February 2018
Installation and Operation Manual
E2K-405-0218 Rev. 2
60
Section 5: Customizing Actuator Settings
Customizing Actuator Settings
Figure 5-13 Analog Setup
NOTE: The actuator senses that the Futronic ACM is installed and adjusts the display sequence to display
only one input.
Analog
Control
<ain1/ain2>
Stayput or
Go To Position
YES
Figure 5-13 Analog Setup
Go to Figure 5-13
Go to Figure 5-13-1
Go to next display
See Figure 5-4
BACK
ANALOG
SETUP?
BACK
NEXT
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
Analog
Input #2
Alarm
<on/off>
YES
AO #1 Source
<position, setpoint,
torque, network>
YES
AO #2 Source
<position, setpoint,
torque, network>
YES
Position
Bandwidth =
<x.x>%
<0.1-5.0% in 0.1%
increments>
Analog Input #1
Alarm
<on/off>
NO
NO
NO
NO
NO
Delay Time =
<xx.xx> SEC
<0-60 sec in 1 sec
increments>
Input
Polarity Close =
<4/20>mA
NO
NO
YES
Output
Polarity Close =
<4/20>mA
NO
YES
<LostSigAction>
On Lost
Signal?
NO
Go to <xx%>
on Lost
Signal?
<0-100% in 1%
increments>
Speed
Bandwidth =
<x.x>%
<0.5-9.0% in 0.5%
increments>
NO
Control Mode Analog?
ACM Installed?
Analog Control AIN 1?
ACM Installed?
Control Mode Analog?
Go to Position on
Lost Signal?
NO
OR
NEXT