Grand total units (GtotU)Figure 5-12:
Multipliers convert the total for 1, 100, 1000, or 1 million units. The meter calculates the
total for display with the programmed multiplier and units.
A custom unit may be selected (CUST), and no multiplier menu will be required. In this
case, use the grand total conversion factor as defined in
Custom units grand total conversion factor (GrtCF).
Press the Enter button at any time, to accept a setting or press the Menu button to exit
without saving changes.
Automatic unit conversions
When switching from any standard unit of rate, total, or grand total to any other standard
unit, automatic unit conversions are performed by the meter.
No unit conversions will be performed when the K-Factor Units (FuNiT) menu is set to
custom (CUST).
A total or grand total unit conversion will automatically change the displayed total and
grand total to the equivalent volume of the newly selected unit.
Custom units entry (USEr)
Select rate, total, or grand total, from a User menu to enter the custom unit.
Setup and programming
User manual 45
To Next Page
Loading...
