Process variable PV SV TV QV
Drive gain ✓ ✓ ✓ ✓
Tube frequency ✓ ✓ ✓
Meter temperature ✓ ✓ ✓
Board temperature ✓ ✓ ✓
Inlet (LPO) amplitude ✓ ✓ ✓
Outlet (RPO) amplitude ✓ ✓ ✓
Live zero ✓ ✓ ✓
PV loop current ✓ ✓ ✓
% of range ✓ ✓ ✓
Two-phase flow severity ✓ ✓ ✓ ✓
API referral
Temperature-corrected density ✓ ✓ ✓ ✓
Temperature-corrected (standard)
volume flow rate
✓ ✓ ✓ ✓
Average temperature-corrected
density
✓ ✓ ✓ ✓
Average temperature ✓ ✓ ✓ ✓
CTPL ✓ ✓ ✓
Concentration measurement
Density at reference ✓ ✓ ✓ ✓
Specific gravity ✓ ✓ ✓ ✓
Standard volume flow rate ✓ ✓ ✓ ✓
Net mass flow rate ✓ ✓ ✓ ✓
Net volume flow rate ✓ ✓ ✓ ✓
Concentration ✓ ✓ ✓ ✓
9.1.3 Configure burst communications
Burst mode is a mode of communication during which the transmitter regularly broadcasts HART digital
information to the network via the primary mA output.
Configure HART burst messages
Display
Menu > Configuration > Inputs/Outputs > Channel A > HART Settings > Burst Message x
ProLink III Device Tools > Configuration > Communications > Communications (HART) > Burst Mode
Field Communicator Configure > Manual Setup > HART > Burst Mode
Configuration and Use Manual Configure digital communications
MMI-20048166 April 2019
Configuration and Use Manual 111
To Next Page
Loading...
