Figure 1-3: 4200 transmitter -- Remote mount
A. Transmitter housing cover
B. Clamping ring
C. Junction box
The transmitter is installed remotely from the sensor. The 9-wire connection between the sensor and
transmitter must be field wired. Power supply and I/O must be field wired to the transmitter. The sensor
connection is in the junction box.
1.4 Communication tools and protocols
You can use several different communications tools and protocols to interface with the transmitter, use
different tools in different locations, or use different tools for different tasks.
Tool
Supported protocols
Display Not applicable
ProLink III • HART
• "Factory Use Only" port in non-hazardous areas
Field Communicator • HART
For information about how to use the communication tools, see Using ProLink III with the transmitter and
Using a Field Communicator with the transmitter in this manual.
Configuration and Use Manual Before you begin
MMI-20048166 April 2019
Configuration and Use Manual 9
To Next Page
Loading...
