ProLink III Device Tools > Configuration > Process Measurement > Velocity > Unit
Field Communicator Configure > Manual Setup > Measurements > Approximate Velocity > Velocity Unit
Velocity Measurement Unit controls the measurement unit used to report velocity.
Procedure
Set Velocity Measurement Unit to the desired unit.
• Default: m/sec
4.8.1 Options for Velocity Measurement Unit
The transmitter provides a standard set of measurement units for Velocity Measurement Unit. Different
communications tools may use different labels.
Configuration and Use Manual Configure process measurement
MMI-20048166 April 2019
Configuration and Use Manual 41
To Next Page
Loading...
