Emerson Rosemount OCX8800 - Table 7-10 Sensor Housing Enumerations; Table 7-11 Cal Results Bit Enumerations; Table 7-12 Calibration Verify State Values; Table 7-13 Calibration Verify Step Values

Section 7: Foundation
Fieldbus
April 2017
Instruction Manual
IM-106-880C, OI
11
0
Calibration Step
Command
Sensor Housing Type
Table 7-10 Sensor Housing Enumerations
SENSOR_HOUSING_TYPE Description
TYPE 1
TYPE 2
TYPE 3
Cal Results
Table 7-11 Cal Results Bit Enumerations
CAL_RESULTS Description
O2 Slope Error
O2 Constant Error
O2 Tolerance Check Failed
CO Slope Error
O2 Constant Error
CO Tolerance Check Failed
CO Slope Warning
Calibration Verify Status
During a running calibration verify procedure, the states below reflect the current step that the
calibration verify is running in.
Table 7-12 Calibration Verify State Values
VERIFY_STATE Description
Idle
Flow High O2 Gas
Flow Low O2 Gas
Flow High COe Gas
Purge Gas
Done
Calibration Verify Step Control
During a calibration, the VERIFY_STATE_ STEP command /parameters control the calibration
verify procedure.
Table 7-13 Calibration Verify Step Values
VERIFY_STATE_STEP Description
Start Flow High O2 Gas
Start Flow Low O2 Gas
Start Flow High COe Gas
Purge Gas
No Effect