4.0 Operating the Alarm System
4.1 Arm the system (all sensors)
Press . It is not necessary to enter the admin code when arming the alarm system.
4.2 Partially arm the system (In-home security)
Press . All sensors in the “Normal-group” are enabled, sensors in the “Home-
group” are disabled.
4.3 Disarm the system using the control panel
Enter your 4 digit password (default: 1234) and press . You will hear a beep to
notify you the system is disarmed. When you hear 3 beeps the password is not
correctly entered.
4.4 Disarm using RFID-tag
Hold the RFID-tag close to the RFID-reader (circle left of the number pad). You will
hear a beep to notify you the system is disarmed. Notice: This feature will only
work when the device is powered by the power adapter and is disabled when
working on backup batteries.
Remark : RFID-tags can only be used to disarm the system not to arm the system.
Remark : When the device is not powered by the power supply you cannot disarm the
system using the RFID-tag.
4.5 Record and playback a personal message
Press to start recording a personal message of max. 10 seconds. When you are
ready press to stop recording. You can playback the message by pressing the
circle.
To Next Page
Loading...