4.6 RFID-tag
With the RFID tag you can disarm the system. You can also assign a name to the
RFID-tag so you will receive a text message with the name of the person that disarmed
the alarm.
Remark: To activate this function you need to store a text message number and
activate the RFID-tag text message function.
Remark : Users can only receive a notification if a mobile-number is stored and the
RFID-tags have a name stored. See chapter “Configure RFID-tag message number”
and “Change RFID-tag identity”.
4.7 Speed-dial
When you press in stand-by mode the system will call a pre-set emergency
number. Press to terminate the call.
4.8 Dial
From stand-by mode you can enter a phone number and call directly to that phone
number by pressing . The system will start dialling the phone number and you are
now able to communicate by the built-in microphone. Press to terminate the call.
To Next Page
Loading...