random button on the remote. If you hear a beep the registration is successful. If
you hear 2 beeps then the remote control has already been registered to the
system.
7.8 Replace the battery
It is very easy to replace the battery (CR2025) of the remote control.
Please remove the rubber cap on the backside of the remote control and remove
the screw underneath.
Now you separate the front and back panel.
Replace the battery and put the front and back panel back together..
Replace the screw and the rubber cap.
8.0 Install motion detector
8.1 front of motion detector
LED indicator :
Flashes continuously : Motion detector is performing a self-test
Flashes 1x : Motion detected
Flashes 2x : Self-test completed. Motion detector is active
Flashes once per 3 seconds : Battery power low, exchange battery*
* You will receive a text message if battery level is low. The message contains the
following information (up to sensor 9) Sensor name with additionally the text ‘battery
almost empty’. From sensor 10 the name will be replaced by a zone nr. with
additionally the text ‘battery almost empty’.
To Next Page
Loading...