The distance between the sensor and the magnet must not exceed 1cm.
Mount both parts with the supplied double-sided tape. You can also choose to mount
the sensor by using screws.
It’s not recommended to install the sensor in a room with a lot of metal. Neither mount
the sensor on constructions. Always check if the red LED will turn on when the door
/window is opened.
9.3.1 Register the window/door sensor
Make sure the sensor and the magnet are located next to each other.
Enter the password and press button on the control panel.
The LED will turn on. Now separate the magnet from the sensor. The sensor will
be triggered. If you hear a beep the sensor is registered to the system. If you hear
2 beeps this indicates this sensor is already registered.
To Next Page
Loading...
