19
ČEŠTINA HRVATSKI ΕΛΛΗΝΙΚΑ ENGLISH
Figure 37
2. Once you start treatment and as you move the appli-
cator around the treatment area, ask the patient to
tell you if the treatment becomes uncomfortable and
adjust the device settings accordingly.
The application force exerted manually varies
and depends on the indication.
For patients with a very low pain threshold, treat-
ment can be started with an Analgesic mode.
Please refer to the “Special Modes” section for
more information.
4.3.3. Pausing / ending the Treatment
When the remaining impulses reach “0”, the treat-
ment automatically stops and the parameters re-
turn to the initial settings.
If treatment is paused for more than 5 minutes,
the treatment parameters return to the initial set-
tings.
1. Press the trigger on the handpiece to pause treatment.
2. Place the handpiece in the handpiece holder.
3. Remove residual gel from the patient
4. Switch off the device
5. Disconnect the handpiece from the unit
00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 1900_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 19 25/03/2021 17:0725/03/2021 17:07
To Next Page
Loading...
Need help?
General
