13
ČEŠTINA HRVATSKI ΕΛΛΗΝΙΚΑ ENGLISH
3.3. SOFTWARE AND HANDPIECE
INFORMATION (NUMBERS OF USE)
1. Press and hold the three buttons simultaneously
and hold them for 5 seconds.
2. The following screen appears. The Software version
is displayed on page 1.
Software version
Page 1
Main (ES-106): 1.1.3
Console HMI (ES-107): 0.8.18
Handpiece (ES-1002): 0.2.2
Figure 15
3. Handpiece information is displayed on page 2. Press
to display page 2.
Handpiece information
Page 2
Piston: 0 treatments, 0 impulses
(1000000 max impulses)
Means: 0.0 bar, 0 Hz, 0 impulses
Handpiece: 0 treatments, 0 impulses
Means: 0.0 bars, 0 Hz, 0 impulses
Figure 16
EMS does not guarantee the performance of the
treatment if the piston has reached its maximum
recommended impulses.
4. To exit the Software and Handpiece information
screen, press and hold the three buttons simul-
taneously and hold them for 5 seconds.
3.4. SETTING THE LANGUAGE
1. Press the three special mode buttons simultaneously
and hold them for 5 seconds.
bar
Hz
Impulses
2.0
15
2500
SMART PROTOCOL
Figure 17
2. The following screen will appear:
No
Yes
Do you want to perform a factory reset?
Figure 18
Changing the language will reset to factory set-
tings. If you have saved a USER protocol, it will
be deleted.
3. Press to conrm that you wish to perform a
factory reset/change the language.
00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 1300_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 13 25/03/2021 17:0725/03/2021 17:07
To Next Page
Loading...
Need help?
General
