26
7. CLEANING AND DISINFECTING
7.1. HANDPIECE
We advise to clean and disinfect the handpiece
after each treatment
1. Clean and Disinfect with a cleaning and disinfectant
wipe such as Surface Wipes Zero from Helvemed,
or equivalent (quaternary ammonium as active
molecule).
Figure 53
7.2. APPLICATORS
Ensure the applicator is cleaned and disinfected
prior to treating a patient. It should take only
about 5 minutes.
1. Disassemble the applicator, the nose, the retaining
nut and the o’rings.
Figure 54
2. Clean and disinfect the applicator with a cleaning and
disinfectant wipe such as Surface Wipes Zero from
Helvemed, or equivalent (quaternary ammonium as
active molecule).
7.3. CONSOLE
We advise to clean and disinfect the console at
the end of the day
1. Turn off the console.
2. Disconnect the power supply connector.
3. Clean and disinfect the surfaces using a cleaning and
disinfectant wipe such as Surface Wipes Zero from
Helvemed, or equivalent (quaternary ammonium as
active molecule).
00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 2600_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 26 25/03/2021 17:0725/03/2021 17:07
To Next Page
Loading...
Need help?
General
