Protocol Filters
This protocol filter enables you to allow and deny access based upon a communications
protocol list you create. The protocol filter profiles are listed in the table at the bottom of the
page.
Note: When selecting items in the table at the bottom, click anywhere in the item. The line is
selected, and the fields automatically load the item's parameters, which you can edit.
Figure 55.
Enable: Click to enable or disable the Protocol filter.
Name: Type the name of the user to be denied access.
Protocol: Select a protocol (TCP, UDP or ICMP) to use for the virtual server.
Port: Type the port range of the protocol.
Add: Click to add the protocol filter to the table at the bottom of the screen.
Update: Click to update information for the protocol filter if user have selected a list item and
have made changes.
Delete: Select a list item and click Delete to remove the item from the list.
Clear: Click to erase all fields and enter new information.
39
To Next Page
Loading...
Need help?
Transmission and Reception
