Transport and storage SPECORD PLUS
36
8 Transport and storage
8.1 Moving the device in the laboratory
CAUTION
Risk of injury during transport
Dropping the device poses a risk of injury and damage to the device.
¡ Proceed carefully when moving and transporting the device. Two persons are re-
quired to lift and carry the device.
¡ Grip the device firmly at the bottom with both hands and lift it simultaneously.
Observe the following when moving the device within the laboratory:
¡ Insufficiently secured components pose a risk of injury!
Before moving the device, remove all loose parts and disconnect all connections
from the device.
¡ For safety reasons, two persons are required to transport the device, one person on
each side of the device.
¡ As the device does not have carrying handles, grip the device firmly with both hands
at the lower end. Lift the device simultaneously.
¡ Observe the guide values and adhere to the legally mandated limits for lifting and
carrying loads without auxiliary means.
¡ Observe the installation conditions at the new location.
8.2 Transport
When transporting the device, observe the safety instructions in the "Safety instructions"
section.
Avoid the following during transport:
¡ Impact and vibration
Risk of damage due to shock, impact or vibration!
¡ Large temperature fluctuations
Risk of condensation!
8.3 Storage
NOTICE
Risk of device damage due to environmental conditions
Environmental influences and condensation can destroy individual components of the
device.
¡ Only store the device in air-conditioned rooms.
¡ Ensure that the atmosphere is free of dust and corrosive vapors.
To Next Page
Loading...
