Endress+Hauser analytikjena SPECORD PLUS - Standards and Directives; Safety, EMC, and Environmental Compliance; EU Directives and Guidelines

Specifications SPECORD PLUS
44
The power values for the SPECORD 250 PLUS are higher by approx. 16VA / 9W in
standby operating states.
The power values for the SPECORD 250 PLUS are higher by approx. 19.5VA / 14W in
the scan operating states.
10.3 Standards and directives
Protection class and protection
type
The device is protection class I. The housing is protection type IP 20.
Device safety
The device complies with the following safety standards
¡ DIN EN 61010-1 (VDE 0411-1; IEC 61010-1)
¡ DIN EN 61010-2-081 (VDE 0411-2-081, IEC 61010-2-081)
EMC compatibility
The SPECORD PLUS has been checked for interference emission and resistance.
The device meets the requirements for interference emission in accordance with
¡ EN 55011 class B
¡ EN 61000-3-2
¡ EN 61000-3-3
¡ EN 61326-1
It meets the requirements for interference immunity in accordance with
¡ DIN EN 613261
Requirements for the use in industrial environments are met with limitations; there
is no interference for electromagnetic fields in the frequency range of 500–
1000MHz up to 6V/m
Environmental and ambient in-
fluences
This device has been tested in environmental simulations under operation and transport
conditions and is in accordance with the requirements in:
¡ ISO 9022-2
¡ ISO 9022-3
EU directives
The device meets the requirements of the directive 2011/65/EU.
The device is designed and tested in accordance with standards meeting the require-
ments of EU directives 2014/35/EU and 2014/30/EU. The device leaves the factory in a
sound condition with regard to technical safety. To maintain this condition and to en-
sure safe operation, the user must strictly observe the safety and operating instructions
contained in this operating manual. For accessories delivered with the device and sys-
tem components from other manufacturers, the information provided in their respective
operating manuals has priority.
Guidelines for China
The device contains substances subject to regulation (according to the directive GB/T
26572-2011). Analytik Jena guarantees that, if the device is used as intended, these
substances will not leak within the next 25 years and therefore will not pose a threat to
the environment or health within this time period.