Deltabar FMD71, FMD72
30 Endress+Hauser
Mechanical construction
Device height
The device height is calculated from
• the height of the housing and
• the height of the individual process connection.
The individual heights of the components are listed in the following sections. To calculate the device
height simply add up the individual heights of the components. Where applicable also take into
consideration the installation distance (space that is used to install the device). You can use the
following table for this purpose:
Section Page Height Example
Transmitter height → 31 ff. (A)
A0021292
Sensor height → 32 (B)
Process connections → 34 (C)
Installation distance - (D)
Device height
To Next Page
Loading...
