Deltabar FMD71, FMD72
62 Endress+Hauser
Certificates and approvals
CE mark
The device meets the legal requirements of the relevant EC directives. Endress+Hauser confirms that
the device has been successfully tested by applying the CE mark.
Ex approvals
• ATEX
• FM
• CSA
• IECEx
• NEPSI
All explosion protection data are given in separate documentation which is available upon request.
Ex documentation is supplied as standard with all devices approved for use in hazardous areas .
Suitability for hygienic
processes
All materials in contact with foodstuffs comply with framework regulation (EC) 1935/2004. The
device is available with hygienic process connections (overview: see order code).
L
CAUTION
Contamination in the process!
Risk of contamination if incorrect seals and parts are used!
‣
To avoid the risk of contamination, when installing the device comply with the design principles
of EHEDG, Guideline 37 "Hygienic Design and Application of Sensors" and Guideline 16 "Hygienic
Pipe Couplings".
‣
Suitable assemblies and seals must be used to ensure hygienic design in accordance with 3-A SSI
and EHEDG specifications.
‣
The leak-proof connections can be cleaned with the cleaning methods typical of this industry
(CIP and SIP). Attention must be paid to the pressure and temperature specifications of the
sensor and process connections for CIP and SIP processes (clean in place/sterilize in place).
The seamless connections can be cleaned of all residue using any of the typical cleaning
methods within this industry.
A0025601
Pressure Equipment
Directive (PED)
The device corresponds to Article 3 (3) of the EC directive 97/23/EC (Pressure Equipment Directive)
and has been designed and manufactured in accordance with good engineering practice or complies
with Category I or II, SEP.
Other standards and
guidelines
The applicable European guidelines and standards can be found in the relevant EU Declarations of
Conformity. The following were also applied:
EN 60529:
Degrees of protection provided by enclosures (IP code)
DIN EN 60770 (IEC 60770):
Transmitters for use in industrial process control systems Part 1: Methods for performance
evaluation
Methods for evaluating the performance of transmitters for control and regulation in industrial
process control systems.
DIN 16086:
Electrical pressure measuring instruments, pressure sensors, pressure transmitters, pressure
measuring instruments, concepts, specifications on data sheets
Procedure for writing specifications in data sheets for electrical pressure measuring instruments,
pressure sensors and pressure transmitters.
To Next Page
Loading...
