Repair Deltabar PMD75B PROFINET with Ethernet-APL
76 Endress+Hauser
13 Repair
13.1 General information
13.1.1 Repair concept
Under the Endress+Hauser repair concept, devices have a modular design and repairs are
carried out by Endress+Hauser Service or by properly trained customers.
Spare parts are grouped into logical kits with the associated replacement instructions.
For more information on service and spare parts contact Endress+Hauser Service.
13.1.2 Repair of Ex-certified devices
L
WARNING
Incorrect repair can compromise electrical safety!
Explosion Hazard!
‣
Repairs to Ex-certified devices must be carried out by Endress+Hauser Service or by
specialist personnel according to national regulations.
‣
Relevant standards and national regulations on hazardous areas, safety instructions
and certificates must be observed.
‣
Use only original Endress+Hauser spare parts.
‣
Please note the device designation on the nameplate. Only identical parts may be used
as replacements.
‣
Carry out repairs according to the instructions.
‣
Only the Endress+Hauser service team is permitted to modify a certified device and
convert it to another certified version.
13.2 Spare parts
• Some replaceable device components are identified by a spare part nameplate. This
contains information about the spare part.
• All the spare parts for the measuring device, along with the order code, are listed in the
Device Viewer (www.endress.com/deviceviewer) and can be ordered. If available, users
can also download the associated Installation Instructions.
Device serial number:
• Located on the device and spare part nameplate.
• Can be read out via the device software.
To Next Page
Loading...
