Accessories Deltabar PMD75B PROFINET with Ethernet-APL
78 Endress+Hauser
14 Accessories
14.1 Device-specific accessories
14.1.1 Mechanical accessories
• Mounting bracket for housing
• Mounting bracket for manifolds
• Manifolds:
• Manifolds can be ordered as an enclosed accessory (screws and seals for mounting are
enclosed)
• Manifolds can be ordered as a mounted accessory (mounted manifolds are supplied
with a documented leak test)
• Certificates (e.g. 3.1 material certificate and NACE) and tests (e.g. PMI and pressure
test) that are ordered with the device apply for the transmitter and the manifold
• During the operating life of the valves, it may be necessary to re-tighten the pack
• Oval flange adapter
• Calibration adapter 5/16"-24 UNF, to screw into vent valves
• Weather protection covers
For technical data (e.g. materials, dimensions or order numbers), see the accessory
document SD01553P.
14.1.2 Plug connectors
• Plug connector M12 90 deg, IP67 5m cable, union nut, Cu Sn/Ni
• Plug connector M12, IP67 union nut, Cu Sn/Ni
• Plug connector M12, 90 deg IP67 union nut, Cu Sn/Ni
The IP protection classes are only maintained if the dummy cap is used or the cable is
connected.
14.1.3 Weld-in accessory
For details, refer to TI00426F/00/EN "Weld-in adapters, process adapters and
flanges".
14.2 Device Viewer
All the spare parts for the device, along with the order code, are listed in the Device Viewer
(www.endress.com/deviceviewer).
To Next Page
Loading...
Need help?
General
