Deltabar S
36 Endress+Hauser
Ack. Alarm Mode 401 Messages Off Off / On
Error No. 595 / 600
115 Sensor over pressure Warning Alarm or Warning
120 Sensor low pressure Warning Alarm or Warning
715 Sensor over temperature Warning Alarm or Warning
717 Transmitter over temp. Warning Alarm or Warning
718 Transmitter under temp. Warning Alarm or Warning
720 Sensor under temperature Warning Alarm or Warning
726 Sens. temp. error overrange Warning/
alarm
5)
Alarm
727 Sens. pres. error overrange
6)
Warning Alarm or Warning
620 Current output out of range Warning Alarm or Warning
Alarm Delay 336 0.0 s 0.0 s
Alarm Displ. Time 480 0.0 s 0.0 s
Current Mode
7)
052 HART Data Signaling
8)
or
Enabled
9)
Signaling
)
or
Enabled
)
Bus Address 345 0 0
After locking:
Config. Recorder
352 Transmitter data
1) After performing the reset with the reset code "7864"
2) Within sensor range
3) According to ordering specifications
4) Depending on the "Press. Sens. Hilim (485)" parameter
5) Alarm setting from firmware version ≥ 02.30.zz
6) Setting influences SFF
7) Only from firmware version ≥ 02.20
8) Onsite display and FieldCare
9) HART handheld terminal
Parameter name Display ID Group Factory
setting
1)
Permitted
settings
Specified
value
Read-out
actual
value
Checked
Company: Date: Signature:
To Next Page
Loading...
