Endress+Hauser Deltapilot S FMB70 - Page 35

Deltapilot S FMB70 Appendix
Endress+Hauser 35
Parameter name Direct
access
Menu path:
Expert
Factory setting
1)
Permitted
settings
Set
point
Actual
value
Tested
Current mode
6)
052 → HART Data Signaling
7)
or Enabled
8)
Signaling
9)
or
Enabled
10)
Bus address 345 0 0
After locking: Config.
counter
352 → Transmitter
data
1) After performing a reset with reset code "7864"
2) Within the lower and upper range limit
3) Depending on the "Press. Sens Hilim (485)" parameter
4) Alarm setting from firmware ≥ 02.30.zz
5) Influence on SFF
6) Only from software version ≥ 02.20
7) Local display and FieldCare
8) HART handheld terminal
9) Local display and FieldCare
10) HART handheld terminal
Date Signature Signature of tester