Endress+Hauser Deltapilot S FMB70 - Page 37

Deltapilot S FMB70 Appendix
Endress+Hauser 37
Parameter name Direct
access
Menu path:
Expert
Factory setting
1)
Permitted
settings
Specifie
d value
Actual
value
Checked
718 Transmitter under
temp.
Warning Alarm o. warning
720 Sensor under
temperature
Warning Alarm o. warning
726 Sens. temp. error
overrange
Warning/alarm
4)
Alarm
727 Sens. pres. error
overrange
5)
Warning Alarm o. warning
620 Current output out
of range
Warning Alarm o. warning
Alarm delay 336 0.0 s 0.0 s
Alarm display time 480 0.0 s 0.0 s
Current mode
6)
052 → HART Data Signaling
7)
or Enabled
8)
Signaling
9)
or
Enabled
10)
Bus address 345 0 0
After locking: Config.
counter
352 → Transmitter
data
1) After performing a reset with reset code "7864"
2) Within the lower and upper range limit
3) Depending on the "Press. Sens Hilim (485)" parameter
4) Alarm setting from firmware ≥ 02.30.zz
5) Influence on SFF
6) Only as of software version ≥ 02.20
7) Local display and FieldCare
8) HART handheld terminal
9) Local display and FieldCare
10) HART handheld terminal
Date Signature Signature of tester