Endress+Hauser iTEMP TMT142B - Page 96

Operating menu and parameter description iTEMP TMT142B
96 Endress+Hauser
Process unit tag
Navigation System → Information → Device location → Process unit tag
Description Use this function to enter the process unit in which the device is installed.
User entry Up to 32 alphanumeric characters (letters, numbers and special characters)
Factory setting 32 x '?'
14.3.5 Submenu: Display
Display interval
Navigation System → Display → Display interval
Description Use this function to set the length of time the measured values are displayed if the values
alternate on the local display. This type of change is only generated automatically if
several measured values are specified.
The Value 1 display - Value 3 display parameters are used to specify which
measured values are shown on the local display.
User entry 4 to 20 s
Factory setting 4 s
Value 1 display (Value 2 or 3 display)
Navigation System → Display → Value 1 display (Value 2 or 3 display)
Description Use this function to select one of the measured values shown on the local display.
Options • Process value
• Device temperature
• Output current
• Percent of range
• Off
1)
1) Not for Value 1 display
Factory setting • Value 1 display: process value
• Value 2 and 3 display: off