Endress+Hauser iTEMP TMT71 - Page 90

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
Operating menu and parameter description iTEMP TMT71/72
Device location submenu
Latitude
Navigation System → Information → Device location → Latitude
Description Use this function to enter the latitude coordinates that describe the device location.
User entry –90.000 to +90.000 °
Factory setting 0
Longitude
Navigation System → Information → Device location → Longitude
Description Use this function to enter the longitude coordinates that describe the device location.
User entry –180.000 to +180.000 °
Factory setting 0
Altitude
Navigation System → Information → Device location → Altitude
Description Use this function to enter the altitude data that describe the device location.
User entry –1.0 · 10
+20
to +1.0 · 10
+20
m
Factory setting 0 m
Location method
Navigation System → Information → Device location → Location method
Description Use this function to select the data format for specifying the geographic location. The
codes for specifying the location are based on the US National Marine Electronics
Association (NMEA) Standard NMEA 0183.
90 V. 1, Rev. 2, 4-10-2018 Endress+Hauser