Endress+Hauser iTEMP TMT71 - Page 91

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
iTEMP TMT71/72 Operating menu and parameter description
Selection • No fix
• GPS or Standard Positioning Service (SPS) fix
• Differential PGS fix
• Precise positioning service (PPS)
• Real Time Kinetic (RTK) fixed solution
• Real Time Kinetic (RTK) float solution
• Estimated dead reckoning
• Manual input mode
• Simulation mode
Factory setting Manual input mode
Location description
Navigation System → Information → Device location → Location description
Description Use this function to enter a description of the location so that the device can be located in
the plant.
User entry Up to 32 alphanumeric characters (letters, numbers and special characters)
Factory setting 32 x '?'
Process unit tag
Navigation System → Information → Device location → Process unit tag
Description Use this function to enter the process unit in which the device is installed.
User entry Up to 32 alphanumeric characters (letters, numbers and special characters)
Factory setting 32 x '?'
HART info submenu
Device type
Navigation System → Information → HART info → Device type
Description Displays the device type with which the device is registered with the HART FieldComm
Group. The device type is specified by the manufacturer. It is needed to assign the
appropriate device description file (DD) to the device.
User interface 4-digit hexadecimal number
Factory setting 0x11D0
Endress+Hauser V. 1, Rev. 2, 4-10-2018 91