Endress+Hauser Liquistation CSF33 - Page 103

Liquistation CSF33 Operation
Endress+Hauser 103
Menu/Setup/Outputs/Current output x:y
1)
Function Options Info
Current output Selection
• Off
• On
Factory setting
Off
Use this function to activate or deactivate a
variable being output at the current output
Source of data Selection
• None
• Connected inputs
Factory setting
None
The sources of data on offer depend on your
device version.
Measured value Selection
• None
• Depends on the Source
of data
Factory setting
None
The measured value you can select depends on
the option selected under Source of data .

The list of the dependent measured values can be found in the Measured value depending on the Source
of data→  103.
Range lower value Range of adjustment and
factory settings depending
on the Measured value
You can output the entire measuring range or
just some of it at the current output. To do so,
specify the upper and lower range values in
accordance with your requirements.
Range upper value
Hold behavior Selection
• Freeze
• Fixed value
• None
Factory setting
Depends on the
channel:output
Freeze
The device freezes the last current value.
Fixed value
You define a fixed current value that is output at
the output.
None
A hold does not affect this current output.
Hold current
Hold behavior = Fixed value
0.0 to 23.0 mA
Factory setting
22.0 mA
‣
Specify which current should be output at
this current output in the hold state.
1) x:y = slot: output number
Measured value depending on the Source of data
Source of data Measured value
pH Glass Selection
• Raw value mV
• pH
• Temperature
pH ISFET
ORP Selection
• Temperature
• ORP mV
• ORP %
Oxygen (amp.) Selection
• Temperature
• Partial pressure
• Concentration liquid
• Saturation
• Raw value nA
(only Oxygen (amp.))
• Raw value μs
(only Oxygen (opt.))
Oxygen (opt.)