Micropilot FMR56, FMR57
Endress+Hauser 15
Slot time 4
Min. delay between PDU 8
Max. response delay 20
Transducer Blocks
Block Contents Output values
Setup Transducer Block Contains all the parameters for standard
commissioning
• Level or volume (channel
1)
(depending on the block
configuration)
• Distance (channel 2)
Advanced Setup
Transducer Block
Contains all the parameters for more accurate
measurement configuration
No output values
Display Transducer Block Contains parameters to configure the onsite display No output values
Diagnostic Transducer
Block
Contains diagnostic information No output values
Advanced Diagnostic
Transducer Block
Contains parameters for advanced diagnostics No output values
Expert Configuration
Transducer Block
Contains parameters that require the user to have
in-depth knowledge of the operation of the device in
order to configure the parameters appropriately
No output values
Expert Information
Transducer Block
Contains parameters that provide information about
the state of the device
No output values
Service Sensor
Transducer Block
Contains parameters that can only be accessed by
Endress+Hauser Service
No output values
Service Information
Transducer Block
Contains parameters that provide Endress+Hauser
Service with information about the state of the
device
No output values
Data Transfer
Transducer Block
Contains parameters for backing up the device
configuration in the display module and for writing
the saved configuration to the device. Access to
these parameters is reserved for Endress+Hauser
Service.
No output values
Function blocks
Block Contents Number of
permanent
blocks
Number of
instantiatable
blocks
Execution
time
Functionality
Resource Block The Resource Block contains all
the data that uniquely identify
the device. It is an electronic
version of a nameplate of the
device.
1 0 - Enhanced
Analog Input
Block
The AI Block receives the
measuring data from the Sensor
Block (selectable via a channel
number), and makes the data
available to other blocks at its
output.
2 3 25 ms Enhanced
Discrete Input
Block
The Discrete Input Block receives
a discrete value (e.g. indicator
that measuring range has been
exceeded) and makes the value
available for other blocks at the
output.
1 2 20 ms Standard
To Next Page
Loading...
