Endress+Hauser Profi Bus Levelflex M FMP40 - Installation in Nozzle ≥ DN300; Installation with Heat Insulation

Levelflex M FMP40
36 Endress+Hauser
Installation in nozzle ≥ DN300
Installation
with heat insulation
• If process temperatures are high, FMP40 must be included in normal tank insulation to prevent the
electronics heating up as a result of heat radiation or convection.
• The insulation may not exceed beyond the points labeled "MAX" in the drawings.
If installation in ≥ 300 mm (12") nozzles is
unavoidable, installation must be carried out in
accordance with the sketch on the right.
L00-FMP4xxxx-17-00-00-en-034
280
> 350
DN300
> DN400
pipe
150…180ø
plate diameternozzle diameter
plate
Approx. flush with
the lower edge of
the nozzle (± 50 mm).
lower edge of
the nozzle
Process connection with adapter
G¾, G1½, ¾NPT or 1½NPT
Process connection with flange DN40 to DN200
L00-FMP40xxx-17-00-00-en-003
L00-FMP40xxx-17-00-00-en-002
MAX
max. 150° C (302° F)
tank insulation
MAX
40
max. 150° C (302° F)
tank insulation