Endress+Hauser Profi Bus Levelflex M FMP40 - Centering Disks

Levelflex M FMP40
Endress+Hauser 65
Centering disks If the probes with rod version are used in stilling well or bypass, it must be ensured that the probe does not
come into contact with the wall. The centering disk fixes the rod probe in the middle of the pipe.
Centering disk PEEK Ø1.89 - 3.74 inch
The centering disk is suitable for probes with a rod diameter of 16 mm and can be used in pipes from DN50 (2")
up to DN100 (4"). Markings on the 4-leg centering disk ensure a simple tailoring. Hence the centering disk can
be adapted to the pipe diameter. See also Operating Instruction BA00377F/00/EN.
• PEEK (statically dissipative)
• Measuring range: -60 °C to +200 °C
Order-no. 71069064
Note!
If the centering disk is inserted in an bypass, it must be positioned below the lower bypass outlet.
The has to be accounted for when choosing the probe length.
Generally, the centering disk should not be mounted higher than 50 mm from the probe end.
It is recommended not to insert the PEEK centering disk in the measuring range of the rod probe.
Centering disk PFA Ø 1.46 inch
The centering disk is suitable for probes with a rod diameter of 0.63 inch (also coated rod probes) and can be
used in pipes from DN40 (1½") upto DN50 (2"). See also Operating Instruction BA00378F/00/EN.
• Measuring range: -200 °C to +150 °C
Order-no. 71069065
max. 50
7
10
Ø 16 (0.63 in)
Ø 48
Ø 75
Ø 95
10
A: ø16.4 (0.65)
B: ø37(1.46)
7.8 (0.31)