Proline Promag H 300
88 Endress+Hauser
Service logbook
Manual
• Create up to 20 user-specific events with a date and customized text in a separate logbook for
documentation of the measuring point
• Use for calibration or service operations, for example, or for maintenance or revision work that has
been performed
Certificates and approvals
CE mark
The measuring system is in conformity with the statutory requirements of the applicable EU
Directives. These are listed in the corresponding EU Declaration of Conformity along with the
standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
C-Tick symbol
The measuring system meets the EMC requirements of the "Australian Communications and Media
Authority (ACMA)".
Ex approval
The measuring device is certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Safety Instructions" (XA) document. Reference is made to this document on
the nameplate.
The separate Ex documentation (XA) containing all the relevant explosion protection data is
available from your Endress+Hauser sales center.
ATEX, IECEx
Currently, the following versions for use in hazardous areas are available:
Ex db eb
Category Type of protection
II2G Ex db eb ia IIC T6…T1 Gb
Ex tb
Category Type of protection
II2D Ex tb IIIC Txxx Db
Ex ec
Category Type of protection
II3G Ex ec ic IIC T5…T1 Gc
cCSAus
Currently, the following versions for use in hazardous areas are available:
IS (Ex i) and XP (Ex d)
Class I, II, III Division 1 Groups A-G
NI (Ex nA)
Class I Division 2 Groups A - D
Ex de
Class I, Zone 1 AEx/ Ex de ia IIC T6…T1 Gb
Ex nA
Class I, Zone 2 AEx/Ex nA ic IIC T5...T1 Gc
Ex tb
Zone 21 AEx/ Ex tb IIIC T** °C Db
To Next Page
Loading...
