Endress+Hauser Proline Promass P 300

To Next Page

To Previous Page

Proline Promass P 300

Endress+Hauser 21

PROFIBUS PA

Manufacturer ID 0x11

Ident number 0x156D

Profile version 3.02

Device description files (GSD,

DTM, DD)

Information and files under:

• www.endress.com

• www.profibus.org

Supported functions • Identification & Maintenance

Simplest device identification on the part of the control system and

nameplate

• PROFIBUS upload/download

Reading and writing parameters is up to ten times faster with PROFIBUS

upload/download

• Condensed status

Simplest and self-explanatory diagnostic information by categorizing

diagnostic messages that occur

Configuration of the device

address

• DIP switches on the I/O electronics module

• Local display

• Via operating tools (e.g. FieldCare)

Compatibility with

earlier model

If the device is replaced, the measuring device Promass 300 supports the

compatibility of the cyclic data with previous models. It is not necessary to

adjust the engineering parameters of the PROFIBUS network with the

Promass 300 GSD file.

Earlier models:

• Promass 80 PROFIBUS PA

– ID No.: 1528 (hex)

– Extended GSD file: EH3x1528.gsd

– Standard GSD file: EH3_1528.gsd

• Promass 83 PROFIBUS PA

– ID No.: 152A (hex)

– Extended GSD file: EH3x152A.gsd

– Standard GSD file: EH3_152A.gsd



Description of the function scope of compatibility:

Operating Instructions →  110.

System integration Information regarding system integration: Operating Instructions →  110.

• Cyclic data transmission

• Block model

• Description of the modules

PROFIBUS DP