EasyManua.ls Logo

Endress+Hauser Proline Promass P 300 - Page 22

Endress+Hauser Proline Promass P 300
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Proline Promass P 300
22 Endress+Hauser
Compatibility with
earlier model
If the device is replaced, the measuring device Promass 300 supports the
compatibility of the cyclic data with previous models. It is not necessary to
adjust the engineering parameters of the PROFIBUS network with the
Promass 300 GSD file.
Previous model:
Promass 83 PROFIBUS DP
ID No.: 1529 (hex)
Extended GSD file: EH3x1529.gsd
Standard GSD file: EH3_1529.gsd
Description of the function scope of compatibility:
Operating Instructions →  110.
System integration Information regarding system integration: Operating Instructions →  110.
Cyclic data transmission
Block model
Description of the modules
EtherNet/IP
Protocol The CIP Networks Library Volume 1: Common Industrial Protocol
The CIP Networks Library Volume 2: EtherNet/IP Adaptation of CIP
Communication type 10Base-T
100Base-TX
Device profile Generic device (product type: 0x2B)
Manufacturer ID 0x11
Device type ID 0x103B
Baud rates Automatic ¹⁰⁄₁₀₀ Mbit with half-duplex and full-duplex detection
Polarity Auto-polarity for automatic correction of crossed TxD and RxD pairs
Supported CIP connections Max. 3 connections
Explicit connections Max. 6 connections
I/O connections Max. 6 connections (scanner)
Configuration options for
measuring device
DIP switches on the electronics module for IP addressing
Manufacturer-specific software (FieldCare)
Add-on Profile Level 3 for Rockwell Automation control systems
Web browser
Electronic Data Sheet (EDS) integrated in the measuring device
Configuration of the EtherNet
interface
Speed: 10 MBit, 100 MBit, auto (factory setting)
Duplex: half-duplex, full-duplex, auto (factory setting)
Configuration of the device
address
DIP switches on the electronics module for IP addressing (last octet)
DHCP
Manufacturer-specific software (FieldCare)
Add-on Profile Level 3 for Rockwell Automation control systems
Web browser
EtherNet/IP tools, e.g. RSLinx (Rockwell Automation)
Device Level Ring (DLR) Yes
System integration Information regarding system integration: Operating Instructions
→  110.
Cyclic data transmission
Block model
Input and output groups
PROFINET
Protocol "Application layer protocol for decentral device periphery and distributed
automation", version 2.3
Communication type 100 MBit/s

Table of Contents

Related product manuals