Proline t-mass 65 Installation
Endress+Hauser
11
To fix the insertion version
2.2.6 Heating
For information on the heating, please see the Operating Instructions on the CD-ROM.
2.2.7 Thermal insulation
For information on the thermal insulation, please see the Operating Instructions on the
CD-ROM.
2.2.8 Vibrations
"
Caution!
Excessive vibration can result in mechanical damage to the measuring device and its mounting.
For information on vibrations, please see the Operating Instructions on the CD-ROM.
a0010114
1. Tighten the compression fitting (1) by
hand to secure the position of the sensor.
Then, using an open-ended wrench
(36 mm), tighten another 1¼ revolutions
in a clockwise direction.
2. Fix the two securing screws (4)
(Allen key 3 mm; 1/8").
#
Warning!
Observe torque:
4 Nm (2.95 lbf ft)
3. Check that the sensor and transmitter do
not turn.
4. Check the measuring point for leaks at
the maximum operating pressure.
1
2
To Next Page
Loading...
