Hardware settings Proline t-mass 65
18 Endress+Hauser
4 Hardware settings
This section only deals with the hardware settings needed for commissioning. All other settings
(e.g. output configuration, write protection, etc.) are described in the associated Operating
Instructions on the CD-ROM.
!
Note!
No hardware settings are needed for measuring devices with HART or FOUNDATION Fieldbus
type communication.
4.1 Device address
Has to be set for measuring devices with the following communication methods:
• PROFIBUS DP/PA
• MODBUS RS485
The device address can be configured via:
• Miniature switches → see description below
• Local operation → see software settings section
Addressing via miniature switches
#
Warning!
Risk of electric shock! Risk of damaging the electronic components!
• All the safety instructions for the measuring device must be observed and all the warnings
heeded → ä 3.
• ESD (Electrostatic Discharge): Use a workspace, working environment and tools purposely
designed for electrostatic sensitive devices.
A0007551
#
Warning!
Switch off the power supply before opening the device.
a. Loosen the cheese head screw of the securing clamp
with an Allen key (3 mm)
b. Unscrew cover of the electronics compartment from
the transmitter housing.
c. Loosen the securing screws of the display module
and remove the onsite display (if present).
d. Set the position of the miniature switches on the
I/O board using a sharp pointed object.
Installation is the reverse of the removal procedure.
1
2
3
4
W
E
N
O
1
2
3
4
W
E
N
O
1
2
3
4
W
E
N
O
1
2
3
4
W
E
N
O
1
2
3
4
W
E
N
O
1
2
3
4
W
E
N
O
a
b
c
d
To Next Page
Loading...
