Endress+Hauser Prosonic S FMU90 PROFIBUS DP - Submenu Pump Control N (Standard - Pump Rate Control)

Operating menu Prosonic S FMU90 PROFIBUS DP
100 Endress+Hauser
Parameter set R13A3 "Pump control N"
• Switch-on point
• Switch-off point
• Min. pump rate/min
• Crust reduction
• Switch on border
• Hook up interval
• Alternate
Parameter set R13A2 "Pump control N"
Pump M
Parameter set R13A3 "Pump M / control N"
• Switch-on delay
• Backlash interval
• Backlash time
• Failure mode
Parameter set R13A6 "Relay allocation → Relay K"
• Function
• Invert
14.6.3 Submenu "Pump control N → Basic setup" (extended - limit
control)
Valid for:
• FMU90-*3**********
• FMU90-*4**********
Navigation to the submenu:
Relay/controls → Pump control N → Basic setup
Parameter set R1401 "Pump control N"
• Reference
• Number of pumps
• Standby pump
• Reset
Parameter set R1402 "Pump control N"
• Function = Limit single/limit parallel
• Load control
Parameter set R1403 "Pump control N"
Pump M
Parameter set R1404 "Pump M /control N"
• Switch-on point
• Switch-off point
• Switch-on delay
• Alternate
• Degree of use
• Max. use time
• Crust reduction
Parameter set R1405 "Pump M /control N"
• Backlash interval
• Backlash time
• Failure mode
Parameter set R1406 "Pump M /control N"
• Pump feedback
• Feedback delay
• Feedb. meaning