Endress+Hauser Prosonic S FMU90 PROFIBUS DP - Submenu Pump Control N → Basic Setup (Extended - Limit Control); Submenu Pump Control N → Basic Setup (Extended - Pump Rate Control)

Prosonic S FMU90 PROFIBUS DP Operating menu
Endress+Hauser 101
Parameter set R1408 "Relay allocation → Relay K"
• Function
• Invert
14.6.4 Submenu "Pump control N → Basic setup" (extended - pump
rate control)
Valid for:
• FMU90-*3**********
• FMU90-*4**********
Navigation to the submenu:
Relay/controls → Pump control N → Basic setup
Parameter set R1401 "Pump control N"
• Reference
• Number of pumps
• Standby pump
• Reset
Parameter set R1402 "Pump control N"
• Function = Pump rat. contr.
• Load control
Parameter set R1504 "Pump control N"
• Switch-on point
• Switch-off point
• Min. pump rate/min
• Hook up interval
• Switch on border
• Alternate
• Crust reduction
Parameter set R1505 "Pump control N"
Pump M
Parameter set R1505 "Pump M /control N"
• Switch-on delay
• Degree of use
• Max. use time
Parameter set R1506 "Pump M /control N"
• Backlash interval
• Backlash time
• Failure mode
Parameter set R1507 "Pump M /control N"
• Pump feedback
• Feedback delay
• Meaning of the feedback
Parameter set R1509 "Relay allocation → Relay K"
• Function
• Invert
14.6.5 Submenu "Pump control N → Storm function"
Valid for:
• FMU90-*3**********
• FMU90-*4**********
Navigation to the submenu:
Relay/controls → Pump control N → Storm function