1. System description
The process display records an analogue measured value. This
value can be monitored using a max. 4 alarm set points.
Additionally a loop power supply is also available.
A clear readable three colour LC display shows the measured
value in digital and bargraph form. Set points, engineering units
as well as set point infringements are permanently displayed.
2. Mechanical installation
Installation hints:
- The installation area must be vibration free.
- The permissible operating ambient temperature
is 0-50°C.
- Protect the unit from heat sources.
Panel installation:
Prepareapanelcutoutof92
+0,8
x92
+0,8
mm(toDIN43700).
Installation depth of the unit is 168 mm.
À Push the unit through the gasket and the front of the panel
cut out.
Á Hold the unit horizontally and fix the jackscrews to their
respective slots (top and bottom).
 Tighten the jackscrews evenly using a screwdriver.
Process display
35
To Next Page
Loading...
