5.4 Service parameters
Parameter Setting up selections
Default
settings
Actual
settings
Time trend monitoring
TRDF
The preset value is the
time base for trend
monitoring
Values:
10 10 seconds
60 60 seconds (1 min.)
600 600 seconds
(10 min.)
see example chapter 6.1
10
TR
DT
Display contrast
DINT
Changes the display
contrast
Values:
1to16
16
DI
NT
Software version
SWID
Display of the unit
software version
The actual version is shown
in the display
SW
ID
Test function
TEST
Test of various unit
components.
After selection using push
button “+” or “-” the
relative function is run.
OFF None
REL1 Relay 1 is energised
REL2 Relay 2 is energised
REL3 Relay 3 is energised
REL4 Relay 4 is energised
DISP all display segments
are activated
An energised relay is the
rest position, in alarm and
set point infringement the
relay de-energises.
OFF
TE
ST
End
END
End of other operation
parameter
Parameter Setting up selections
Default
settings
Actual-
settings
Service Code
SERV
Operation address for the
factory set parameter
release code. These
values must not be
changed if the unit is to
operate correctly!
----
SC
OD
LIME
SE
AV
Process display
49
To Next Page
Loading...
