5. Operating parameter description
5.1 Input parameters
The addresses identified by * as well as “possible settings”
are only available dependent on the previously set up
parameter or the options released. The following listing
shows the maximum possibilities.
Once changes have been made to the setting up
parameters in the groups analogue input and
display/measurement range, please check the possible
effects these could have on other groups.
Parameter Setting up selections
Default
settings
Actual
settings
Measurement range
RANG
Current input 4...20 mA, 0...20 mA
RANG
4-
20
Voltage input 0...1 V, 0...10 V
Voltage input
(Only with “Universal
input” option)
±20 mV, ±50 mV, ±100 mV,
±200 mV, ±1 V, ±2 V, ±5 V,
±10 V
Thermocouple
(Only with “Universal
input” option)
Typ T, Typ J, Typ K, Typ R,
Typ S, Typ B, Typ N, Typ U,
Typ L
RTD
(Only with “Universal
input” option)
Pt100, Pt500, Pt1000
Ni100
Units
DIM1 DIM2 DIM3 DIM4
Selection of engineering
units
(presettable)
Value:
see table Chapter 6.2
There are four fields available
DIM1 = top left to
DIM4 = bottom right
DIM 1 %
DIM 2
DIM 3
DIM 4
Signal damping
DAMP
Damping the input
signals
Value:
0to9999s
0
DA
MP
Decimal point
DP
Selecting the decimal
point position
Selection:
0 to 3 decimal points
000,0
DP
Display value 0%
SCLO
Display value at 0%
sensor value
Value:
-999to9999
The scale is preset on
temperature measurement!
0,0
SC
LO
CH
AN
LIME
Process display
45
To Next Page
Loading...
